Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[2014CVO]

Hi, I’m converting my HDI rear lights back to original USA domestic setup. Can someone please post a photo of their USA domestic model 2014 CVO Breakout rear turn lights and rear tail lamp connections, including wiring into connectors. My photos are attached for current HDI setup. I’m just not sure how to connect the new domestic lights (wiring) to my connector. Would love to see the wires from lights to connector and connector to main harness for both rear lights and lamp.  Cheers and very much appreciated…stop by anytime for free beers.  Thank you.

[2014CVO]

Current lamp and rear right turn connectors picture attached…May someone please show me USA domestic setup.

[2014CVO]

Current rear left turn  connector picture attached…May someone please show me USA domestic setup.

[2014CVO]

These are the rear tail Harley sold me…I believe and hope they are USA domestic?

[2014CVO]

A couple of beers later, reviewing electrical diagrams and how to disconnect and connect new pins to Deutsche connectors and, by George, I think I’ve got it.

[Tractor Bubba]

Congratulations on getting it sorted out!
Good luck on your project.

[2014CVO]

Cheers Tractor Bubba. All installed except need pins to do final connections under the seat and install Custom Dynamics rear light inserts. Then off to the dealer to get BCM  changed back to USA settings. Looking forward to seeing how the rear run/brake lights look which are stuck to the underside of the fender.