TODAY'S UPDATE:
Went by the shop today to reveiw the electronics phase of Cybil II's mods. Glad I did. I didn't realize that only I could determine where I want the Zumo located. Since this is a permanent installation, I wanted it to be as unobtrusive (not like me) as possible. We found a good spot for it on the left side of the handlebars, but angled the TechMount so it sits directly behind the bar itself, behind the clutch master cyl. So we went over all the req'ts for mounting and wiring it. Taking the advice here and wiring it, along with the 2WheelTunes Amp, to the Accessory Switch.
Then we reviewed the req'ts for the 2WT system. Artie's going to internally wire the front speakers, which will mount under the mirrors, where the original Turn Signals were located. The Amp mounts on the crossmember on the downtubes. We can't internally wire the Audio Output Wire from the Zumo from the amp, without cutting into the Jack. So the Audio Signal wire will be mounted externally.
So until the KTP arrives, I'll be able to use this system with the front speakers alone. I need to locate an 8 foot Audio Cable to connect the Rear Hawg Wired Amp to the Zumo as well.
I'll also need a 2 foot length, and some kinda coupling, for a quick connect of the TP Audio Wire. Anyone have a source for this?

He also was installing the Xetronics HID lighting as I was leaving. Unfortunately, he's off tomorrow and Fri, so I probably won't see the bike this weekend.
Bummer, it's supposed to be real nice. But they got the wrong front tire in anyway. They were sent a D-402 non-radial, in my size. But they have the D-407 Radial held at another HD dealer. I'll pick it up tomorrow and drop it off to them on Sat.
Feuling is sending out the rest of the hardware so everything matches. I'll get them on when I receive them. When the KTP arrives, we'll just have to mount the Amp and Crossovers, do some additional wiring, and my Baby will be completed for this season!!!

Don't ask, Pics to follow when I get it back next week!

Hoist!
