Topic: darn it, head gasket leak (Read 2768 times)

Twolanerider · « **Reply #15 on:** May 18, 2010, 08:45:07 PM »

With the length of the standard couplers commonly available all else you'll need is two pieces of hose cut to 4.5" each. That length lets the coupler straighten out nicely right in between the frame and the coil on a touring bike. Haven't put the clamps on this one yet but it shows all the little bit you're doing for this little task.

Twolanerider · « **Reply #16 on:** May 18, 2010, 08:46:20 PM »

Quote from: sadunbar on May 18, 2010, 08:14:23 PM

Get two fittings....and make a couple of quick disconnect fuel tank drain lines!

Yeap, and I think that was Scott's idea. Those nine fingered guys are smart!

sadunbar · « **Reply #17 on:** May 18, 2010, 08:50:52 PM »

Quote from: Twolanerider on May 18, 2010, 08:46:20 PM

Yeap, and I think that was Scott's idea. Those nine fingered guys are smart!

hehehe... I guess that leave 8 good idea's left in me.....

Author Topic: darn it, head gasket leak (Read 2768 times)

Twolanerider

Re: darn it, head gasket leak

Twolanerider

Re: darn it, head gasket leak

sadunbar

Re: darn it, head gasket leak