looked over the service supplement for 2014, to remove dash the tank need slid back. No taking off the fork lock switch like the other 2014 bikes. different lock all together. No problem to me as tank has to come off for the wiring to run under the cover...
anyone know a source for the rubber grommets to wire the lights through crash bar?
Any part store, harbor freight, ace hardware will have rubber grommets. When I installed my acc. kit, I didn't remove anything, I removed the two screws holding the painted cover at the tank area, and I was able to get a swivel socket tool and remove the two screws holding in the switch. Then I just connected the new one to the harness and put it back in. I had just filled mine up, so I wasn't that enthused at the time to remove the tank, so I looked underneath at the switches and thought I could do it without removing anything, and I did. Everything is already there and wired, it just needs to be connected to the new switches.
For wiring the harness that came with the switches, it connects to the acc. connection in the side panel at the fuse box or under the seat if it has already been moved to there. If it is still in the side panel, then move it to underneath the seat and connect the new harness to it. I didn't connect the harness on mine, because I didn't have anything that I was trying to power with it, I just wanted the blank buttons to light up and have writing on them, and so I would be ready in the future, if and when I do need the power, so I installed the switches and put the harness back in the box and set it on my shelf for when it is needed.